Jan20

When changing injector sleeves on Cummins Series of engines, it's been standard practice to clean the casting seat area of the casting with a wire brush, included in our Injector Sleeve Removal & Installation Kit.

Many advanced machine shops, utilize our Casting Seat Cutter to insure proper Injector Sleeve Seating/Sealing prior to injector sleeve installation, in addition to brush casting clean.

This Casting Seat Cutter is found in our Casting Repair Kit, which is required for rebuilding of the casting seat area that has developed cracks and/or has excessive casting wear.

Oversized (thick nosed) injector sleeves are not available and proper seating of the injector into the injector sleeve is a concern. Currently, with this Cummins ISX / QSX Series, it is not advised to remove any more casting material than suggested.

Suggested procedures to clean up any casting distortion and/or sealing serrations:

  • a) In a machining center (seat & guide machine), using casting seat cutter (416-6156-28) with the driving arbor (414-6114-10) and the appropriate guide bushing (416-6156-32) clean up the casting seat with a .002 to .003 cut (.005 maximum).
  • b) In cutting, the seat cutter should be operated at about 60/80 RPM and should be kept well lubricated at all times with our Irontite Tap-O (468-9920-08).

If removal of more casting material is required, then it is advised to install one of our Taper Threaded repair plugs in order to build up this casting seat area, found in our Casting Repair Kit.


Nov15

Hello

Posted by on 11/15/11  ~  Posted in: Welcome  ~  Send feedback »

Welcome to our Blog!  This seems like a good way to get some more information out to the people that use our products and those who are thinking about using our products. This blog is where we will provide helpful information and insite to the processes and procedures related to all the Irontite Product Line.

Visitors are invited and encouraged to comment on our Notes so that others might benefit from their experiences and expertise or their questions.  As much as we try, we still have the ability to leave out some details that others will be quick to point out.  The end result should be better information for all.

In order to leave comments or to subscribe to this blog, visitors will need to register and provide some basic information.  Mainly we will require your email address.  It's how this system will notify you if you requested to be notified and it helps us to determine that you are a real live person rather than one of those evil spam robots that are so annoying.

Visitors who register and provide their email address are, by doing so, agreeing to be contacted on occassion via email with promotional or informational messages as well.  Irontite does not currently have a regularly scheduled mailing such as a newsletter, but should one be implimented the email address provided here by you is your act of giving your permission to be included to receive a regularly scheduled mailing in the future.  As always, you will be able to unsubscribe is you don't wish to receive more mailings.

We sincerely hope that you find benfit from the information provided here and welcome your feedback.

1 2 4 5